CFLNP - PRE-COTE LATEX PVA SEALER, 95-100
- MSDS: CFLNP
- Manufacturer: PRESERVATIVE PAINT CO
- Product Name: PRE-COTE LATEX PVA SEALER, 95-100
- National Stock Number: 8010-00N024843
Product Identification
Product ID:PRE-COTE LATEX PVA SEALER, 95-100
MSDS Date:03/03/1993
FSC:8010
NIIN:00N024843
MSDS Number: CFLNP
Responsible Party
SEATTLE, WA 98108
US
Emergency Phone: 800-424-9300 (CHEMTREC)
Info Phone: 206-763-0300
Cage: 86589
Contractor
Cage: 86589
Ingredients
TITANIUM OXIDE; (TITANIUM DIOXIDE)
CAS: 13463-67-7
RTECS: XR2275000
Fraction By Weight: 10-<20%
OSHA PEL 15 MG/M3 TDUST
ACGIH TLV: 10 MG/M3 TDUST
CALCIUM CARBONATE
CAS: 1317-65-3
RTECS: EV9580000
Fraction By Weight: 10-15%
OSHA PEL 15 MG/M3 TDUST
ACGIH TLV: 10 MG/M3 TDUST
TALC (POWDER), CONTAINING NO ASBESTOS FIBERS; (MAGNESIUM
CAS: 14807-96-6
RTECS: WW2710000
Fraction By Weight: 10%
OSHA PEL 2 MG/M3
ACGIH TLV: 2 MG/M3
MAGNESIUM ALUMINUM SILICATE; (ORGANO CLAY)
CAS: 8031-18-3
Fraction By Weight: <5.0%
OSHA PEL N/K
ACGIH TLV: N/K
0.24
RTECS: 9999999VO
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE & CHRONIC: OVEREXP TO ETHYLENE
GLYCOL MAY CAUSE CNS DEPRESS; CARDIOPULM FAILURE, LIVER AND KIDNEY
DMG AND BIRTH DEFECTS. CHRONIC: RPRTS HAVE ASSOC RPTD/PRLNG OVEREXP
TO SOLV WITH PERM BRAIN AND NERV SYS DMG. UNDER NORMAL CONSUMER
USECONDITIONS THE LIKELIHOOD OF ANY ADVERSE HLTH EFTS ARE LOW.(EFTS
OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:INHAL: NOT NORMALLY A HAZ UNLESS
SPRAYED. OVERSPRAY AND SPRAY MIST ARE PRIMARILY CONSIDERED NUISANCE
DUSTS. SKIN & EYES:RPTD/PRLNG LIQ CONTACT MAY CAUSE SKIN IRRIT WITH
DISCOMFORT AND DERM. M AY CAUSE IRRIT OR BURNING OF EYES. INGEST:
MAY CAUSE GASTRO-INTESTINAL DISTRESS.
Medical Cond Aggravated by Exposure:NO MEDICAL CONDITIONS ARE KNOWN TO
BE AGGRAVATED BY EXPOSURE TO THIS PRODUCT.
First Aid
First Aid:INGEST: DRINK A GLASS OF WATER AND CALL MD IMMED. DO NOT
INDUCE VOMIT. INHAL: REMOVE TO FRESH AIR. IF NOT BREATHING, GIVE
ARTIFICIAL RESPIRATION, PREFERABLLY MOUTH-TO-MOUTH. IF BREATHING
DIFFICULTLY P ERSIST OR OCCURS LATER, CONSULT MD. EYES: FLUSH WITH
WATER FOR AT LEAST 15 MIN. CALL MD. SKIN: REMOVE CONTAMINATED
CLOTHING AND WASH EXPOSED AREA WITH SOAP AND WATER.
Fire Fighting
Extinguishing Media:FOAM, ALCOHOL FOAM, CO*2, DRY CHEMICAL, WATER FOG,
OTHER.
Fire Fighting Procedures:COOL CLOSED CONTAINERS WITH WATER FOG TO
PREVENT PRESSURE BUILDUP. USE NIOSH APPROVED SCBA AND FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS MAY EXPLODE DUE TO A
BUILD UP OF STEAM PRESSURE WHEN EXPOSED TO EXTREME HEAT.
Accidental Release
Spill Release Procedures:VENTILATE AREA. PREVENT SKIN CONTACT AND
BREATHING OF VAPOR.CONFINE AND REMOVE WITH INERT ABSORBANT
MATERIALS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:OBSERVE LABEL PRECAUTIONS. KEEP
CLOSURES TIGHT WHEN NOT IN USE. STORE IN AN UPRIGHT POSITION TO
PREVENT LEAKAGE.
Other Precautions:DO NOT EXCEED STORAGE BETWEEN 40 DEG. F AND 120 DEG.
F. KEEP AND STORE OUT OF REACH OF CHILDREN. DO NOT SAND, FLAME CUT,
BRAZE OR WELD DRY COATING WITHOUT WEARING A NIOSH APPROVED
RESPIRATOR OR APPROP RIATE VENTILATION.
Exposure Controls
Respiratory Protection:FOR BRUSH AND ROLLER APPLICATION, RESPIRATORY
PROTECTION IS NOT NORMALLY REQUIRED. FOR SPRAY APPLICATION, A
PROPERLY FITTED VAPOR/PARTICULATE NIOSH APPROVED RESPIRATOR IS
REQUIRED.
Ventilation:SUFFICIENT IN PATTERN AND VOLUME TO KEEP VAPORS BELOW
APPLICABLE OSHA REQUIREMENTS.
Protective Gloves:SOLVENT IMPERVIOUS GLOVES
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:ANSI APPROVED EYE WASH & DELUGE SHOWER .
COVERALLS ARE RECOMMENDED. A SOLVENT IMPERVIOUS APRON IF BODY
CONTACT.
Work Hygienic Practices:WASH THORO AFTER HNDLG & BEFORE EATING/SMKNG.
WASH CONTAM CLTH BEFORE USE. PERIODIC MONITORING OF (SUPP DATA)
Supplemental Safety and Health
WORK HYGENIC PRAC: EXPOSURE LEVELS/LIMITS RECOMMENDED.
Chemical Properties
Boiling Pt:B.P. Text:212F,100C
Vapor Density:HVR/AIR
Spec Gravity:1.3 (H*20=1)
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:MODERATE
Appearance and Odor:MILKY WHITE TO VARIOUS COLORS WITH A FAINT AMMONIA
ODOR.
Stability
Stability Indicator/Materials to Avoid:YES
NONE REASONABLY FORESEEABLE.
Stability Condition to Avoid:NONE REASONABLY FORESEEABLE.
Hazardous Decomposition Products:OXIDES OF CARBON.
Disposal
Waste Disposal Methods:DO NOT ALLOW MATL TO CONTAMINATE GROUND WATER
SYSTEMS. ABSORB LARGE SPILLS WITH INERT ABSORBANT MATERIAL. DISPOSE
OF ABSORBED MATERIAL IN ACCORDANCE WITH FEDERAL, STATE AND LOCAL
REGULATORY REQUIREMEN TS. DO NOT INCINERATE IN CLOSED CONTAINERS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.